Description
Epinox SAN-05 Cream Siphon SET CONTENTS Aluminum bottle Aluminum Cap 3 pieces decoration holders Decoration holders cleaning brush Protection cap Tube container USING INSTRUCTIONS If you are going to use the whipped cream siphon for the first time or after a long time; Rinse the bottle with warm and then cold water. Fill the bottle with well-chilled fresh whipped cream or other ingredients depending on your recipe. Do not fill the bottle with more than the capacity marked on the bottle. To prevent lumps, make sure that the solids in the material are completely dissolved before filling it into the bottle. Place the gasket on the cap and close the bottle properly by rotating the cap. If no screw thread is visible on the bottle, it means the cap is closed properly. Do not cross-seal. Place the cream tube (8g N2O) into the tube container. It is recommended to use original tubes, but you can also use 8g N20 tubes of Liss or ISI standards. Attach the tube container to the valve by rotating until a hissing sound is heard. Use 1 tube for each filling. Shake the bottle upright four to five times. When using well-chilled light cream or other mixture, shake up to ten times, loosening the tube container and tube. A slight hissing sound when loosening is normal. Remove the metal tube. These tubes can be used as scrap and are recyclable. For squeezing, hold the bottle upright with the decoration holder facing down. There should be a distance of approximately 1 cm between the holder and the surface where you will squeeze the cream. Gently press the trigger; if the cream is not firm enough, shake the bottle once more. Do not shake again while continuing to use. MAINTENANCE INSTRUCTIONS Do not use sharp or abrasive objects to clean the bottle. Do not place the whipped cream siphon in the freezer or freezer. Do not expose the whipped cream siphon to heat (stove, sun, microwave, etc.). Open the whipped cream siphon only when the pressure is completely lost. Press the trigger until the hissing sound stops. During cleaning, remove only the parts specified in the maintenance instructions. All parts can be easily assembled. For this reason, you do not need to use force. For your safety, do not lean over the product during the process. Blockages may occur in the valve due to the bottle being filled with solid materials. In such cases, proceed as follows: Do not attempt to remove the headgear in any way! Place the bottle on the counter and wait for the contents to settle to the bottom. Afterwards, cover the nozzle with a thick fabric and press the trigger several times until the gas is completely released. If you still cannot loosen the cap, contact the company from which you purchased the product. Attention: Use only original spare parts! Never use parts of the product with other products or similar products from other manufacturers. Do not try to make changes to the product. If possible, use the original tubes. Siphons and tubes are pressurized products, care and caution must be taken when using them. Never use the product when it is damaged. Keep the siphon and tubes out of the reach of children.Whipped cream siphon can only be used for the preparation of cream and similar liquid products. Keep this instruction booklet.